Review
Fibaro Walli Outlet/Power Socket
Installation on Domoticz:
We are the first to ensure that the Walli is installed in its place. Make sure you first disconnect the power and connect it according to the supplied schematic. Power it up after this.
Then log in to Domoticz and go to the menu item "setup" and "hardware". Then press the setup at the Aeon Labs controller and press "include node secure". There will be a popup that the controller is in learning mode. Then press the add button 3x with a small screwdriver. The LED will flash green and then light up white to indicate that the addition was successful.
Installation screens:
Configuration:
Control:
On-off switch:
Energy measurement:
Example event:
As an example we make that if there is movement and the lux value is lower than 5, then the Walli is switched on. We use a Fibaro Motion Sensor as a trigger and to read the lux value.
