INNR Smart Filament Bulb vintage (RF-261/RF-264)

Installation at the Vera Plus:

The Vera Plus has built in Zigbee chips so adding this bulb shouldn't be a problem. The first step is to remove the old lamp. I always make sure to take the power off. Safe, we then turn the INNR back in. For this I use a cloth to ensure that there are no stains on the lamp.

After this we provide it with power. The lamp will flash momentarily to indicate that it is in learning mode. Then we log in to the Vera and go to our devices. We then click on "add device" and select Generic Zigbee because we cannot find the INNR via the search engine. After a few times on the next you will be asked to put the lamp in learning mode. You can do this by switching the lamp on and off once. It will flash briefly again.

I see it appear on my dashboard. It took me a while until the correct configuration came into view. I can dim the lamp and turn it on/off.

If adding it does not work, you can also reset the lamps by turning it on/off 6x.

Control:

I get an on / off switch and a dimmer.

Example Scene:

I would like 15 minutes before the sun sets for the INNR to be turned on. As a bonus, I also set the condition that someone must be home.