INNR Smart Plug - SP-220 (SP-120)

Installation on ZipaTile/ZipaBox:

The next controller is the ZipaTile/ZipaBox from Zipato. This hub has support for the Zigbee protocol, so adding it shouldn't cause too much trouble. We log into the ZipaBox first and go to our devices.

We then click on Zigbee and see the countdown begin. To add the intermediate plug, we hold down the button on the top for 5 seconds. The LED will flash red and then green to indicate that the addition was successful. This is also the case because I see in the Zipabox that it has been found.

When we go to our devices, we don't see it. That does not bode well. If we look at the configuration, we see that there is no type associated with the intermediate plug. Unfortunately, only Zipato can handle this so we cannot use this device.