Review:
Neo Coolcam Door sensor
Installation via the ZipaTile/ZipaBox:
We are also going to install this sensor on the ZipaBox. We log in to the online environment and go to our devices. Then we click on "add new device" and then on Z-Wave.
Now we have to remove the tab at the battery and hold the add button for 5 seconds until it lights up white. When we release it I see the LED flashing red and the ZipaBox indicates that the reset was successful. Now we have to repeat everything again but now the LED will blink blue when I release it.
It takes a very long time before the add screen disappears. Unfortunately I get a "configuration fail" message. This sensor is therefore not use with my Zipabox v1.
Installation screens:
Table of content
;
;