Neo Coolcam Motion Sensor (5in1)

Installation via the Homey:

The first controller to which we are going to add the sensor is the Homey from Athom. The first step is to power the sensor. You can do this by unscrewing the back and removing the 2 tabs.

After this we log in to the Homey and go to our devices and press the plus sign. I then search for Neo Coolcam, when I look at the results I don't see the sensor listed. So we are already trying to add Generic Z-wave. You can do this by clicking on Homey and then on Z-wave.

Now I have to put the sensor in learning mode. You can do this by holding down the button on the sensor until the LED lights up white. Then release it and I see it flash red and the Homey gives a confirmation. Now we have to repeat this procedure again. Now I see the LED flashing blue indicating it can be added. Unfortunately, the process does not continue after this and the sensor cannot be added.