Review:
Neo CoolCam Motion Sensor v3
Installation on the Fibaro Home Center 2:
The next controller is the HC2 from Fibaro. The adding is done again by putting the controller in the "add" position and supplying the motion sensor with power again. You can do this by logging in and going to your devices and then clicking "add and remove device". Then tick "add node secure" and press "add".
Now remove the tab from the battery and press the button on the inside 3x. After this he was added to the HC2. I get a message that no template is available yet. Despite this, I can see the movements, brightness and temperature neatly on the dashboard.
Installation screens:
Configuration:
Operation:
In case of movement, the sensor will transmit a status to the controller and the LED of the sensor will light up red. We also get a light measurement and temperature measurement. You can determine how often it comes in during the configuration.
Example scene:
We create the scene that if there is movement and the lux value is lower than 5, then the lamp may be switched on.
