Neo CoolCam Motion Sensor v3

Installation on the Fibaro Home Center 3:

To add this sensor we go to the configuration (radar icon) section and click on "devices". Then click on the blue plus in the top corner and click on Z-Wave. We then power the sensor by removing the tab near the batteries. Now we have to press the button on the inside 3x to really start adding. In see the LED lights up red, which means that it has been found. This is also the case, because I see it appear in the HC3.

I see a motion, lux and temperature sensor. Completely complete and everything works too.

Operation:

In addition to the motion sensor, we get a temperature and lux sensor. If there is movement, the LED of the sensor will light up. You can set the interval of the lux and temperature sensor via the configuration.

Example scene:

We create as a scene: if there is movement, and the lux value is lower than 5, then the lamp may be switched on.